Week1: First Meeting for the Spring Semester

This week we had a first meeting. My team and I were working on the bill of material. According to Ron, the full scale prototype now has to be shortered by 6m, instead of 9m long. This is a big challenge for the solar team because we have to change our previous design to meet the new requirements and aslo to reduce the cost of materials.

Comments

Post a Comment

Popular posts from this blog

Week 11 and 12: Working on CFD and Presentation

Image
This week, I still worked on the CFD and prepared for the second presentation. There were updates on meshing methods as well as the other setups, see the result below.  The drag force and lift force got improved comparing to the previous simulation; however, the drag- coefficient and lift- coefficient still do not make sense.  For the next step, I will talk to Dr.Thurlow and other people who have more experience in CFD to take a look at my setup.  After that, I will work on FEA to complete our analysis. 
Read more

Week 13 and week 14: Fabricating the Prototype and Work on the Finite Element Analysis

Image
In these two weeks, I focused on building the prototype and finishing up the FEA for the solar rack. For building the prototype, I meet up with my team to fabricate the prototype and to figure out the best way to building the parts faster.  Below is the progress that I make so far on the hand-calculation drag coefficient and drag lift. These data will be implemented in ANSYS to run for the FEA in next couple days. Source: https://file.scirp.org/pdf/JFCMV_2016012909451497.pdf Wind analysis including cooling effects and lift prevention. D d = C d ⍴ V 2 2 A D l = C l ⍴ V 2 2 A Where D d is wind drag   D d , D l : drag and lift forces, C d , C l : drag and lift coefficient relatively, ⍴ is the density of air, V is velocity of wind which has V peak and V storm , and A is the reference area or cross-sectional area of the lowest point of calcul. Wind load calculation has to be calculated using the following values. ⍴ = 1.225 kg/m 3 , V could be...
Read more

Week5 & 6: Water Gutter Design and Solar System Connections

Image
This week, I focused on the design of water gutter and finished the BOMs. For the water gutter, the main purpose is to collect the water and reuse it. In Figure1, a water gutter was designed so that it prevents leaves from falling into the gutter, which may cause the flowing of water gutter. This design will then be implemented with my ME106 project ( see Figure 2). Figure 1: A design for water gutter with helmet In Figure 2, I will use a turbidity sensor to sense the quality of water and an ultrasonic sensor to measure the water level inside a container. When the detected water is clean, a valve will be opened to let the clean water goes in while the valve for the dirty container remaining close. All the data will then be collected by using Matlab. Figure 2: A block diagram to show how the clean water will be collected  Also, I did some research and helped my partner completed the bill of materials. All the materials that we need for the project includes th...
Read more