Week 4: Solar Charge Controller with Solar Panel

This week, I did some research on the solar panel system. To have a fully functional structure for the Maker Faire,  we need a system that can provide enough energy for the full-scale bogie. For that to happen, we need a solar charge controller and a DC to AC inverter.

There are various options to buy the solar charge controller and the inverter; however, we need to know for sure the total power output of eight solar panels before we can purchase them. For this week, my solar team needs to talk to Dr. Furman and full-scale team to ensure we are on the right track before we buy the solar charge controller and the inverter.

Comments

Post a Comment

Popular posts from this blog

Week 13 and week 14: Fabricating the Prototype and Work on the Finite Element Analysis

Image
In these two weeks, I focused on building the prototype and finishing up the FEA for the solar rack. For building the prototype, I meet up with my team to fabricate the prototype and to figure out the best way to building the parts faster.  Below is the progress that I make so far on the hand-calculation drag coefficient and drag lift. These data will be implemented in ANSYS to run for the FEA in next couple days. Source: https://file.scirp.org/pdf/JFCMV_2016012909451497.pdf Wind analysis including cooling effects and lift prevention. D d = C d ⍴ V 2 2 A D l = C l ⍴ V 2 2 A Where D d is wind drag   D d , D l : drag and lift forces, C d , C l : drag and lift coefficient relatively, ⍴ is the density of air, V is velocity of wind which has V peak and V storm , and A is the reference area or cross-sectional area of the lowest point of calcul. Wind load calculation has to be calculated using the following values. ⍴ = 1.225 kg/m 3 , V could be...
Read more

Week 7 and 8: CFD Simulation and Updated Bill of Materials

Image
In the week 7 & 8, I focused on the Bill of Materials and CFD simulation. For the Bill of Materials, I figured out what components to buy such as charge controller, converter, transformer, and batteries. Since the motor from the Bogies team needs a power of 150W and run on DC voltage, it is necessary to have a transformer that can supply an exact power of 150W to the team. The updated Bill of Materials can be seen in Figure 1 below. Figure 1: Bill of Materials for added components For the CFD simulation, I was learning how to use the software and how to set up the boundary conditions to get the most accurate result. In the video, it showed my progress on learning CFD simulation. I expect to finish in week 9, so that I can use the result such as drag coefficient, drag force, drag lift, and lift force from CFD simulation to run the FEA. 
Read more

Week5 & 6: Water Gutter Design and Solar System Connections

Image
This week, I focused on the design of water gutter and finished the BOMs. For the water gutter, the main purpose is to collect the water and reuse it. In Figure1, a water gutter was designed so that it prevents leaves from falling into the gutter, which may cause the flowing of water gutter. This design will then be implemented with my ME106 project ( see Figure 2). Figure 1: A design for water gutter with helmet In Figure 2, I will use a turbidity sensor to sense the quality of water and an ultrasonic sensor to measure the water level inside a container. When the detected water is clean, a valve will be opened to let the clean water goes in while the valve for the dirty container remaining close. All the data will then be collected by using Matlab. Figure 2: A block diagram to show how the clean water will be collected  Also, I did some research and helped my partner completed the bill of materials. All the materials that we need for the project includes th...
Read more